ROLL CALL – Roll Call ##
Time Rule Overview##
If the employee clocks in earlier before the shift starts, and the time is before the shift starts is greater than the value defined in the band (e.g. 10 minutes before the shift starts) than that band time before shift will be replaced with the time code defined on the time rule. In case the employee should not have this TR applied the waiving mechanisms should be used.• Defect description from the documents attached to defect: “If the employee punches in more than 10 min prior to the start of the shift and attends Roll Call they should receive 10 min of time in a separate time code from their shift time. If the employee punches in less than 10 min prior to the start of the shift they should just round to the start of the shift and not receive roll call time. If the employee punches in on time to receive roll call but does not attend then a timekeeper will manually remove the awarded time from the employee.”
Requirements / Features#
Time Rule Type Code: ROLL CALL
Additional Info #
Frequency predefined as Every Shift Only one Band is supported
Implementation# The time rule should be set up in IDWR as shown below.
Cycle Frequency Seq Time Rule Type Band From To Value Day Time Code Premium Target Time Code Set Apply Time Code Set Action Every Shift 1590 Allowed No No # of days to look back [1] Allowed Required [2] No Required [3] Required [4] Add [1] [2] Remove the time rounding rule IDWR( Details tab) [3] Target Time Code Set must contain CLOCK IN EARLY time codes only. [4] Roll coll target time code set should include only clock in early time code
