TR_ROLL_CALL

ROLL CALL#

Time Rule Overview#

If the employee clocks in earlier than the start time of the shift (e.g. 10 minutes before the shift starts), and the difference between the clock in time and shift start time is greater than the value defined in the band on the time rule, than the time within the band before the shift will be replaced with the time code defined on the time rule.

Specifications#

Requirements / Features#

[1] If left blank system default will be 5
[2] Frequency predefined as Every Shift
[3] Sequence should be provided
[4] Time Rule Type ROLL CALL
[5] Band will be the amount of time in minutes the employee can clock in before the start of the shift in which this time rule will be applied
[6] Day can be used to specify which day of the week the rule applies
[7] This will be the time code that will be used when this time rule fires
[8] Target Time Code Set must contain CLOCK IN EARLY time codes only
[9] Apply Time Code is not allowed
[10] Can be waived should default as enabled. This must be enabled to waive this rule for individual employees

Additional Info #

Set the Time Rounding Rule on IDWR to null( Details tab)

Implementation#

The time rule should be set up in IDWR as shown below;
CycleFrequencySeqTime Rule TypeBandFromToValueDayTime CodePremiumTarget Time Code Set Apply Time Code SetActionCan be Waived
[1]Every Shift[2][3]ROLL CALL[4]# of Min[5]NoNoNoAllowed[6]Required[7] NoRequired [8]No[9]ReplaceYes [10]