The following are helper
Time Rules that apply different
time codes depending on the clock punch and employee schedule:
- CLOCK IN EARLY
- Applies defined time code when an employee clocks IN earlier then scheduled time
- CLOCK IN LATE
- Applies defined time code when an employee clocks IN later then scheduled time
- CLOCK OUT EARLY
- Applies defined time code when an employee clocks OUT earlier then scheduled time
- CLOCK OUT LATE
- Applies defined time code when an employee clocks OUT later then scheduled time
- UNKNOWN LEAVE
- Applies defined time code when we have for any leave time type that does not have associated time code
- MISSED PUNCH
- Applies the defined time code for scheduled time where the clocks are missing
- The MISSED PUNCH time code is being applied only in the past until current time.
- We now support target time code set for this time rule.
- Any time that it is added through time exceptions and creates time with a time code that is not in the target time code set will not be included in missing punch logic.
- Time Code used should use Missed Punch time type (setup in IDTC)
- NON OVERLAY LV
- Addresses the issue of Leaves entered on WETTS and WEALP that do not respect the Adjust Scheduled Time toggle on IDTC
- SCALE ROUND DFN
- Controls the result of the Time Rule DY PERCENT TP UP, defining the scale and rounding type.
Click to create a new notes page
Screen captures are meant to be indicative of the concept being presented and may not reflect the current screen design.
If you have any comments or questions please email the Wiki Editor
All content © High Line Corporation