The following are helper Time Rules that apply different time codes depending on the clock punch and employee schedule:
  • CLOCK IN EARLY
    • Applies defined time code when an employee clocks IN earlier then scheduled time
  • CLOCK IN LATE
    • Applies defined time code when an employee clocks IN later then scheduled time
  • CLOCK OUT EARLY
    • Applies defined time code when an employee clocks OUT earlier then scheduled time
  • CLOCK OUT LATE
    • Applies defined time code when an employee clocks OUT later then scheduled time
  • UNKNOWN LEAVE
    • Applies defined time code when we have for any leave time type that does not have associated time code
  • MISSED PUNCH
    • Applies the defined time code for scheduled time where the clocks are missing
    • The MISSED PUNCH time code is being applied only in the past until current time.
    • We now support target time code set for this time rule.
    • Any time that it is added through time exceptions and creates time with a time code that is not in the target time code set will not be included in missing punch logic.
    • Time Code used should use Missed Punch time type (setup in IDTC)
  • NON OVERLAY LV
    • Addresses the issue of Leaves entered on WETTS and WEALP that do not respect the Adjust Scheduled Time toggle on IDTC
  • SCALE ROUND DFN
    • Controls the result of the Time Rule DY PERCENT TP UP, defining the scale and rounding type.

Notes #

Click to create a new notes page